Good Driving Practices

o Never take the car out of gear and coast down a hill. This is extremely hazardous. Always leave the car in gear.

o Don't "ride" the brakes. This can cause them to overheat and malfunction. Instead, when you are driving down a long hill, slow down and shift to a lower gear. When you do this, engine braking will help slow the car.

o Slow down before shifting to a lower gear. This will help avoid over-revving the engine, which can cause damage. o Slow down when you encounter cross winds. This gives you much better control of your car.

o Be sure the car is completely stopped before you attempt to shift into reverse. The transaxle can be damaged if you do not. To shift into reverse, depress the clutch, move the shift lever to neutral, wait three seconds, then shift to the reverse position.

o Exercise extreme caution when driving on a slippery surface. Be especially careful when braking, accelerating or shifting gears. On a slippery surface, an abrupt change in vehicle speed can cause the drive wheels to lose traction and the vehicle to go out of control.

WARNING:

o Always buckle-up! In a collision, an unbelted occupant is significantly more likely to be seriously injured or killed than a properly belted occupant.

o Avoid high speeds when cornering or turning.

o Do not make quick steering wheel movements, such as sharp lane changes or fast, sharp turns.

o The risk of rollover is greatly increased if you lose control of your vehicle at highway speeds.

o Loss of control often occurs if two or more wheels drop off the roadway and the driver oversteers to reenter the roadway.

o In the event your vehicle leaves the roadway, do not steer sharply. Instead, slow down before pulling back into the travel lanes.

o Never exceed posted speed limits.

    See also:

    Owner maintenance precautions
    Improper or incomplete service may result in problems. This section gives instructions only for the maintenance items that are easy to perform. As explained earlier in this section, several proced ...

    Spark plugs
    Make sure to install new spark plugs of the correct heat range. ...

    Record your key number
    The key code number is stamped on the bar code tag attached to the key set. Should you lose your keys, this number will enable an authorized HYUNDAI dealer to duplicate the keys easily. Remove the ...